Main Breaker Panel Installation – Source and Resource

Your garage is stocked with an electric motor. Take note of this if you have no experience working with electricity, please seek out an expert from your local electrical service company.

This video is a demonstration of the Square D Homeline 100amp breaker box. It’s important to make sure that it’s mounted securely. It is on the wall in the barn where the wires are inserted through the floor and go into the rafters. Though there are four conductors, only three of them are required here. For the wires to be able to flow into the box, a coupling is essential. The next step is to connect the wires in your box. Before you plug in the wires then, you must take the wires off their ends. Following that, utilize a screwdriver for tightening them. Install the safety stickers to protect against accidental touches of the Lugs. Install the 30-amp duel pole breaker. The breaker should simply start to work. Similar to the 20 amps, they are also required to snap into. Finally, the wire must be pulled back to its top, and plugged into the circuit breaker.


Leave a Reply