Measure the length of the assembly starting from the connector’s top to the connector’s end closest to you. Next, measure the part closest to the end. The second measurement is taken at the top of the connector at the opposite end up to the start of the spiral on the side nearest to the connector. The difference between these two measurements will be the length of your connector.
Length of entire assembly will determine the best location of the support sleeve. Support sleeve is a metal ring that is placed around the hose that provides protection against Kinking, and also provides support to it is built of steel. Additionally, it serves as an obstruction for the GIC nuts, which means that they is not able to be tightened beyond the support sleeve.
The saying is that you should measure twiceand cut only once. It’s the same with the hoses made of metal. The extra effort of taking measurements can make a huge difference in cash and stress later on.
Measurement of the length of the metal hose is one of the most important steps in the procedure of installing it. In the absence of accurate measurements, you are at chance of damaging the hose. This can be costly repair or even replacement. c8mkd6y9z6.